Removing stains from your sex doll

To remove stains from your sex doll, use a TPE Stain Remover such as those found on Amazon or a 10% benzoyl peroxide cream normally used against pimples.

How do you use these resources?

In summary, apply a small amount (10ml) of the TPE Stain Remover or benzoyl peroxide cream to the stain and let it sit for a few hours. It is advisable to test this on an inconspicuous area first to avoid damaging the material. After it has taken effect, carefully wipe off the residue with a soft cloth and lukewarm water. Repeat this process if necessary, but avoid excessive use, as chemicals can damage the structure of the TPE material.

Step-by-step guide

1. Clean the surface – Before tackling the stain, it is important to gently clean the affected area with a soft cloth and lukewarm water. Use mild cleaning agents such as green soap and lukewarm water, as these will not damage the TPE material.
   
   
2. Use TPE Stain Remover or Benzoyl Peroxide 10% – Apply a small amount (10ml) of the remover to the stain and leave it for 6 to 12 hours. Check in between to see if the stain fades. Repeat the treatment if necessary. Use cellophane wrap over the stains (like a tattoo) to enhance the effect, do this for very stubborn stains.
   
   
3. Wipe thoroughly – After the stain is gone, clean the treated area with a damp cloth and mild soap to remove any residue from the remover or cream. Repeat steps 2 and 3 until the stain is gone.
   
   
4. Maintenance and prevention – To prevent new stains, it is advisable to always clean your sex doll thoroughly after use. Do not dress her in dark clothing that may give off stains and store her in a clean, dry place.

With this method your sex doll will stay in top condition longer and you can continue to enjoy without worrying about unwanted stains. Good luck!

Important warnings

Although this method can be effective, the use of chemical products always carries risks. Excessive use or incorrect application can lead to damage to the material. Therefore, we recommend testing carefully on a non-visible surface and always follow the instructions on the product packaging.